Making covers for the Teak dorade boxes was a challenge!

I made paper patterns by tracing each face, then hacked them together.
I screwed up the first one, but after that figured it out. They ain't perfect, but it's good enough for me.

Note that the vinyle cowls have different shapes. That's because they catch different kinds of breezes.

Handrail covers aren't very exciting. There were existing snaps screwed into the deck, so I used them. I don't like them, but they're there.

Later, I replaced the handrails with Stainless.

The little canvas cover for the MOB pole took about 10 minutes to make.

You can probably figure out what this is.

The wheel cover was made using the old one as a pattern, but I made it a bit bigger so I can put it on while the table is still attached to the pedestal.
The trim around the actual wheel is triple thick for
chafe protection.